(1) All technological processes using toxic, irritating and flammable substances should be placed in a separate workshop, or arranged in a specially separated section of the workshop, and equipped with personal protective equipment and fire-fighting equipment.
(2) The passages for transporting logs, sawn timber and waste materials in the workshop should be equipped with facilities to eliminate ventilation such as corridors, entrance halls, door curtains, curtains, etc., as well as facilities to prevent the spread of fire such as automatic fire doors, fire and smoke dampers, water curtains Wait.
(3) Overpasses with protective railings and stairs should be installed when it is necessary to safely reach the jobs above the equipment in the workshop. Non-slip floors shall be laid on the factory floor and overpass passages.
(4) There should be no equipment and even lines on the commonly used pedestrian passages. The width is not less than 1m.
(5) The conveyor belt below the ground should be covered with a cover plate or a grid-shaped protective plate. The metal plate surface should be non-slip. The gap width of the grid protection shall not exceed 30mm.
(6) Sawdust and waste storage tanks should be placed outside the workshop.
