(1) The machine tool should be kept clean, and the transmission parts and rotating connection points should be kept lubricated.
(2) It is strictly forbidden to stack sundries on the machine tool.
(3) Check whether the screws on the cylinder flange and cylinder rod and the fastening flange of the upper pressure plate are loose once a day.
move and tighten in time
(4) Check the oil circuit once a day for leakage and repair it in time.
(5) Check the oil in the oil tank once a week: focus on checking whether the oil is too dirty and replace it in time: oil
Whether the amount is sufficient, and refill it in time.
(6) Check the use of the positioning rollers, lifting balance gears and racks of the pressure plate once a day.
B. Maintenance of the machine tool during operation
(1) Operate the machine tool according to the correct operation method, and it is strictly forbidden to press workpieces that exceed the original design processing range.
(2) Place the workpiece in the correct way, and it is strictly forbidden to pressurize on the side and pressurize unevenly.
